Selecting the Barrier Parameters

You can select the parameters present in the Barrier card.

Before you begin: You must first select the input file and prepare the component (see Selecting an Input File and Preparing the Component). In addition, you must select the BARRIER accessory in the LS-DYNA Prepare Wizard.

  1. Double-click the LS-DYNA component icon .

    The LS-DYNA Component Editor appears.

  2. In the LS-DYNA Component Editor, click the Input tab.

  3. Click the Barrier subtab.

    The Coordinate area displays the difference and rotation information of the coordinate.

    The RIGIDWALL area displays the X, Y, and Z values of POINT_1 and POINT_2

  4. If you want to specify the Difference value of each axis, you can click the check box corresponding to the value and type the value directly in the entry box.

  5. Select the parameters you want to use in your Isight model by doing any of the following:

    Option Description
    Click the check box Select an individual parameter.
    Check Select all the parameters.
    Uncheck Clear all the selected parameters.

  6. Add the selected parameters to the Parameter area at the bottom of the component editor.

    Click to add the selected parameters to the Parameter area.

    Click to remove the selected parameters from the Parameter area.

    The parameters added to the Parameter area are added to Isight and can be used with your Isight model.

  7. Click to move the selected parameter up in the table, or click to move the selected parameter down in the table.

  8. Click OK to save your changes and to return to the Design Gateway.