Defining contact pairs in Abaqus/Standard


In this section:

About contact pairs in Abaqus/Standard
Assigning surface properties for contact pairs in Abaqus/Standard
Assigning contact properties for contact pairs in Abaqus/Standard
Modeling contact interference fits in Abaqus/Standard
Adjusting initial surface positions and specifying initial clearances in Abaqus/Standard contact pairs
Adjusting contact controls in Abaqus/Standard
Defining tied contact in Abaqus/Standard
Extending master surfaces and slide lines
Contact modeling if substructures are present
Contact modeling if asymmetric-axisymmetric elements are present