After executing a job, select the Logs tab in
the Runtime Gateway.
Detailed information about the job is displayed.
Note:
If the log information indicates that
model execution failed, click Rerun Job in the
lower right corner of the tab (see Re-Running Failed Jobs).
If desired, change the following settings:
| Option |
Description |
|---|
| Show log for selected component only |
Displays
information for a single component. Only information for the component
selected in the model explorer is displayed. |
| Log Level |
Allows you to specify the information
displayed in the messages area. The available options are: Debug,
Info, Warning, Error,
and SysError. The default setting is Warning.
This filters the messages that were actually logged during the job. If
the job specified that it would only log messages of a certain level,
changing the filtering here does not allow you to view messages below
that level because, in fact, the messages were never logged. You can
change the default by setting a preference option. For information about
changing the default and the type of messages shown for each option,
see Setting Execution Preferences.
|
Select a message from the list to view the entire message in the message
area (below the list).
If desired, click the Job Overview, Job
Sizing, and Run Summary subtabs at
the bottom of the tab to view information about the job such as the model
name, job identification, status, and the model hierarchy. For more information,
see Viewing Job Information,
View Job Size Information,
or View the Run Summary.
|